Source
Adapted from my own handwritten and hand-typed notes from Year 1 to Year 3 of my EEE degree
Thermal noise
Every resistor and receiver input makes random thermal noise, caused by the random motion of electrons. It sets the lowest signal level that a receiver can detect.
Terms:
- J/K: Boltzmann constant
- : temperature in kelvin, usually K
- : receiver bandwidth in Hz
At 290 K, the noise power density is -174 dBm/Hz, so:
| Bandwidth | Noise floor |
|---|---|
| 1 kHz | -144 dBm |
| 1 MHz | -114 dBm |
| 20 MHz | -101 dBm |
A wider bandwidth lets in more noise. This is why narrowband links reach further.
Signal-to-noise ratio
Each modulation scheme needs a minimum SNR to decode with an acceptable error rate.
Noise figure
A real receiver adds its own noise. The noise factor and noise figure NF measure how much the SNR gets worse through a stage:
A perfect stage has NF = 0 dB. A typical LNA has NF of about 0.5 to 2 dB. A passive loss (cable or filter) before the receiver has NF equal to its loss.
Friis formula for cascaded stages
The first stage has the largest effect. A low-noise amplifier (LNA) with high gain at the front makes the noise of later stages small. Any loss before the LNA adds directly to the noise figure, so the LNA goes as close to the antenna as possible.
Receiver sensitivity
Example: MHz, NF = 6 dB, dB:
The required SNR depends on the modulation, see Modulation Basics.