Source
Adapted from my own handwritten and hand-typed notes from Year 1 to Year 3 of my EEE degree
Why matching matters
Most RF systems use a characteristic impedance for cables, connectors and inputs. When a load such as an antenna has a different impedance , part of the signal reflects back toward the source. Less power reaches the antenna, and the reflected power can harm a transmitter amplifier.
Reflection coefficient
Cases:
- : , no reflection (matched)
- (short) or (open): , all power reflects
The reflected power fraction is .
VSWR, return loss and mismatch loss
The forward and reflected waves form a standing wave on the line.
| VSWR | Return loss | Reflected power | Mismatch loss | |
|---|---|---|---|---|
| 1.0 | 0 | infinite | 0% | 0 dB |
| 1.5 | 0.2 | 14 dB | 4% | 0.18 dB |
| 2.0 | 0.33 | 9.5 dB | 11% | 0.51 dB |
| 3.0 | 0.5 | 6 dB | 25% | 1.25 dB |
A VSWR below 2 is the usual target for an antenna across its band.
Worked example
A 75 Ω antenna on a 50 Ω cable:
Only 4% of the power reflects, so the loss is small (0.18 dB).
How to match
Methods:
- matching network: an L-network of one inductor and one capacitor transforms to
- quarter-wave transformer: a line of impedance
- tune the antenna: trim its length, since a long antenna resonates too low and a short one too high
The match is measured with a vector network analyser (VNA) as , which is the return loss as a negative number in dB.
A well-matched antenna feeds the signal into the receiver chain, where noise sets the limit, see Thermal Noise and Noise Figure.