Source

Adapted from my own handwritten and hand-typed notes from Year 1 to Year 3 of my EEE degree

What an antenna does

An antenna converts a guided signal on a cable into a radio wave in free space, and back again. The same antenna works the same way for transmit and receive (reciprocity).

Key parameters

Parameters:

  • directivity: how much the antenna focuses power in its best direction, compared with an isotropic antenna that radiates equally in all directions
  • gain: directivity multiplied by efficiency, , given in dBi
  • radiation pattern: a plot of gain against direction, with a main lobe, side lobes and nulls
  • beamwidth: the angle of the main lobe between its -3 dB points (half-power beamwidth)
  • bandwidth: the frequency range where the antenna is well matched, usually where VSWR is below 2
  • polarisation: the direction of the electric field (vertical, horizontal or circular)

An antenna does not add power. A high-gain antenna takes power from other directions and puts it in its main lobe.

Common antenna types

TypeTypical gainPatternUse
Half-wave dipole2.15 dBiOmnidirectional around its axisReference antenna, Wi-Fi
Quarter-wave monopoleabout 2 to 5 dBiOmnidirectional, needs a ground planeDrone and RC receivers
Patch6 to 9 dBiDirectionalDrone video, GPS
Yagi-Uda8 to 15 dBiDirectionalLong-range point to point
Horn10 to 25 dBiHighly directionalTest and measurement
Parabolic dish20 dBi and moreVery narrow beamSatellite, backhaul

Antenna size

A half-wave dipole is about long, in practice about 95% of that.

Example: at 2.4 GHz, cm, so a half-wave dipole is about 6 cm long.

Polarisation mismatch

Losses:

  • same linear polarisation: 0 dB
  • linear antennas at 90° to each other: in theory infinite, in practice about 20 dB or more
  • linear to circular: 3 dB
  • opposite circular (left-hand to right-hand): about 20 dB or more

Drone video links often use circular polarisation, because the drone tilts and turns and the signal reflects off surfaces.

Near field and far field

The pattern and gain values hold in the far field:

where is the largest size of the antenna.

An antenna only works well when it is matched to its cable, see Impedance Matching and VSWR.