Source
Adapted from my own handwritten and hand-typed notes from Year 1 to Year 3 of my EEE degree
The small-signal models are linear approximations of non-linear devices. They are only valid while the AC input at the transistor stays small enough that the higher-order terms can be ignored.
BJT Limit
For to be proportional to , the square term must be much smaller than the linear term:
MOSFET Limit
Linear if , taken as
Because can be several volts, a MOSFET handles much larger signals than a BJT.
Allowed Source Amplitude per Amplifier
The limit is on or , not on . Working back through the source divider and any emitter or source resistor gives:
| Amplifier | Largest |
|---|---|
| C-E | |
| C-C | |
| C-B | if |
| C-S | |
| C-D | |
| C-G |
Key idea: an unbypassed emitter or source resistor (or the load in a follower) puts most of the input across itself, so with the input can be increased well beyond 5 mV.
Example
C-E stage with mS, Ω, and : mV, compared with 5 mV if were fully bypassed.
The C-E stage itself is covered in Common-Emitter Amplifier.