Source
Adapted from my own handwritten and hand-typed notes from Year 1 to Year 3 of my EEE degree
A transistor amplifies when it is biased in the right region: forward-active for a BJT, saturation for a MOSFET. In these regions a small change at the input terminal causes a large change in output current, and a load resistor turns that into a large voltage change.
Bias and the Q-Point
Bias sets the quiescent (idle) current and voltages with no signal present. The Q-point, found by DC analysis, decides:
- the small-signal parameters (, , )
- the voltage gain, input resistance and output resistance
- the largest input and output signal before distortion
- power consumption and efficiency
BJT Example
V, kΩ, Q-point at mA, V with µA. The input is V.
The output follows the load line :
- an 8 mV peak change in gives about 5 µA change in
- this gives a 0.5 mA change in
- this gives a V change in
The output is inverted ( phase shift), because a rise in lowers .
MOSFET Example
V, kΩ, V, Q-point . A 1 V peak-to-peak change in gives 1.25 mA peak-to-peak in and 4 V peak-to-peak in , so the gain is only about . A MOSFET needs a much larger input swing than a BJT for the same current change.
Small Signals Only
The waveforms stay undistorted copies of the input only while the input change is small, because the device curves are exponential (BJT) or square law (MOSFET). Separating the circuit into a DC part and an AC part is done with DC and AC Equivalent Circuits.