Feedforward control computes the command a system should need from a model, before any error appears. Feedback then only corrects what the model gets wrong. Most real motor controllers use both. It complements a Feedback Control System.

Feedback Only Versus Feedforward Plus Feedback

Feedback only:

  • the controller must first see an error before it acts
  • to respond fast it needs high gains, which can cause oscillation

Feedforward plus feedback:

  • the model gives most of the command at once
  • the feedback controller only trims small errors, so its gains can be small and stable

Simple Speed Example

For a motor whose speed is roughly proportional to duty cycle:

  • is the measured speed at full duty
  • limiting the PID output (for example to of full duty) keeps the feedback as a small correction

Common Feedforward Terms

  • velocity feedforward: command proportional to the target speed
  • acceleration feedforward: extra torque for the target acceleration, from the inertia
  • gravity compensation in robot arms: the torque needed to hold each joint against gravity
  • friction compensation: a minimum command to overcome static friction

Limits

  • feedforward needs a reasonable model, and a wrong model gives a wrong command
  • it cannot reject disturbances it does not know about, which is why feedback is still needed