Source
Adapted from my own handwritten and hand-typed notes from Year 1 to Year 3 of my EEE degree
An ideal amplifier has the same gain at every frequency. Real circuits contain capacitors (and inductors) whose impedance changes with frequency, so the gain and phase change too. The transfer function captures this.
Transfer Function
It is a property of the circuit only, not of the input. It is found with normal circuit analysis (KVL, KCL, dividers) after replacing each element by its impedance:
| Element | Relation | Impedance |
|---|---|---|
| Resistor | ||
| Capacitor | ||
| Inductor |
Independent sources inside the circuit are disabled; dependent sources stay. The frequency response is , found by putting .
General Form
Terms:
- is the low-frequency gain
- zeros are the roots of the numerator, at
- poles are the roots of the denominator, at
Properties
Rules:
- coefficients of a physical circuit are real, so poles and zeros are real or come in complex conjugate pairs
- poles and zeros may lie in the left half-plane (LHP) or right half-plane (RHP)
- poles in the LHP () give decaying responses and a stable circuit, RHP poles give a growing exponential
- the pole frequency is always a positive number, even though the pole location is negative
Canonical Form
Write every factor as either (a zero at the origin) or , so each factor is 1 at low frequency. Example:
Splitting :
So it is a gain of 40 dB times two high-pass sections (poles at 10 and rad/s) and one low-pass section (pole at rad/s). This form makes the Bode plot easy to sketch.