Source

Adapted from my own handwritten and hand-typed notes from Year 1 to Year 3 of my EEE degree

Finding the DC operating point of a MOSFET circuit is an assume-and-check process.

Procedure

Steps:

  • assume saturation unless the region is obvious
  • use KVL with to find
  • compute from , then from the drain loop
  • check the assumption ( for saturation)
  • if it fails, redo with the triode equation
  • when a quadratic gives two roots, reject the one with (device would be off)

Example 1: Triode Region

V, gate tied to so V, kΩ, µA/V², V.

Assume saturation:

  • mA
  • V, which is less than V, so wrong

Use the triode equation with :

Roots are 8.7 V (impossible, above ) and 2.3 V. So V V (triode confirmed) and mA.

Example 2: nMOS Two-Resistor Bias

MΩ from drain to gate, kΩ, V, µA/V², V.

No gate current flows through , so and the device is saturated.

Roots are V (cutoff, rejected) and 2 V. So V and µA.

Example 3: pMOS Two-Resistor Bias

V, kΩ (gate to drain), kΩ to ground, µA/V², V.

Again , and

Roots are 0.37 V (below , rejected) and 3.45 V. So V and µA.

Amplifier circuits normally use the four-resistor bias instead.