Automatic gain control adjusts a receiver's gain so the signal level entering the ADC stays in a good range when conditions change. A typical example is a WiFi monitor carried from a quiet room into a busy office: the band gets much louder, and the gain must come down. The integral part of its controller needs the protection in Integral Windup and Anti-Windup.

Why It Is Needed

  • an ADC has a fixed range, for example 12 bits
  • too much gain: strong signals clip, which creates false frequency content
  • too little gain: weak signals sink into quantisation noise
  • the right gain changes with place, time and interference

Measure, Then Adjust

Each frame:

  • measure a level, often the noise floor or the average power
  • compute the error,
  • update the gain with a controller, usually in incremental form
  • if the floor is too high, the error is negative and the gain goes down

Practical Limits

  • clamp the gain to the hardware range, for example 0 to 76 dB
  • slew-rate limit: at most a few dB of change per frame, because a sudden large increase can clip a strong burst that appears at the same moment, and smooth changes keep the data consistent over time
  • anti-windup on the integral, because the gain often sits at a limit
  • audio AGCs often react fast when the level is too high (to stop clipping) and slowly when it is too low

Two Stages For Machine Learning

  • a hardware loop changes the radio gain so the ADC is well used
  • a software step then shifts every frame so its noise floor sits at one fixed level (for example dB)
  • the model then sees inputs with the same statistics as its training data, whatever the radio gain was

Testing Without Hardware

Unit tests on synthetic frames can check:

  • the gain moves in the right direction for too much and too little noise
  • the step never exceeds the slew limit, and the gain never leaves its range
  • the loop converges within a set number of frames
  • the loop recovers after it has been stuck at a limit