The speed of a DC motor depends on its average voltage. A microcontroller cannot output an adjustable voltage, so it switches the supply on and off very fast (PWM), and an H-bridge lets the motor turn in both directions. This is the electronic side of DC Motor Speed Control.

Pulse Width Modulation

How it works:

  • a square wave with a fixed frequency
  • the duty cycle is the fraction of each period that the output is on
  • the motor's inductance and inertia smooth the pulses, so the motor responds to the average voltage

How a microcontroller makes it:

  • a counter counts from 0 up to a wrap value (TOP), then starts again
  • the output is high while the count is below a compare level
  • with no clock divider, the PWM frequency and duty are
  • example: a 125 MHz clock with TOP gives kHz

Choosing the frequency:

  • above about 20 kHz the motor makes no audible whine
  • too high a frequency increases switching losses in the transistors

H-Bridge

How it works:

  • four switches around the motor, in the shape of the letter H
  • top-left and bottom-right closed: current flows one way, the motor turns forward
  • top-right and bottom-left closed: current flows the other way, the motor turns backward
  • both bottom switches closed: the motor terminals are shorted, which brakes the motor

What must never happen:

  • both switches on the same side closed at once, which shorts the supply (shoot-through)
  • drivers add a short dead time between turning one switch off and the other on

Common driver interface:

  • one direction pin and one PWM pin per motor (sign and magnitude)
  • the software sets the direction pin from the sign of the command and the PWM duty from its size

Bipolar Versus MOSFET Drivers

  • older bipolar drivers such as the L298N lose about 2 V across their transistors, which turns into heat, and the motor gets less voltage
  • MOSFET drivers have a very small on-resistance, so the voltage drop and the heat are much lower

Practical Points

  • deadband: below a minimum duty the motor cannot overcome static friction and does not move, so controllers often raise any small non-zero command to that minimum
  • the minimum can be found with a test that steps the duty down until the motor stops
  • flyback: when a switch opens, the motor's inductance keeps the current flowing, so diodes (or the MOSFET body diodes) must give it a path
  • two "identical" motors are rarely identical, so open-loop commands drift, and closed-loop speed control with encoders fixes it