Source
Adapted from my own handwritten and hand-typed notes from Year 1 to Year 3 of my EEE degree
Volumes are found by slicing a solid into thin pieces whose volume is easy, then integrating. Three versions: general cross-sections, discs and cylindrical shells. They extend the strip idea used for areas.
Volume by Cross-Sections
If the solid lies between and and the cross-section at has area (continuous), a slice of thickness has volume :
Steps:
- Sketch the solid and one typical cross-section
- Find a formula for
- Find the limits and
- Integrate
Worked example: a wedge is cut from a cylinder of radius by a plane perpendicular to the axis and a second plane at through the centre line. A typical cross-section is a rectangle of width and height , for :
Disc Method
A solid of revolution comes from spinning a region about a line. Slicing perpendicular to the axis gives discs of radius :
where is the distance from the axis to the curve. (If the region has a hole, a slice is a washer: .)
Worked example: rotate the region under , , about the -axis.
Worked example: rotate the region bounded by , and about the line . Radius is :
Cylindrical Shell Method
Slicing parallel to the axis gives thin cylindrical shells. A shell with radius , height and thickness has volume about (unroll it into a thin slab). For the region under , , spun about a vertical line:
Worked example: rotate the region bounded by , the -axis and about the -axis. Shell radius , height :
Discs or Shells
| Method | Slice relative to axis | Integrate along |
|---|---|---|
| Disc or washer | perpendicular | the axis of rotation |
| Shell | parallel | perpendicular to the axis |
Pick whichever gives a single, simple integral.